Форум arduino.ua

Andrey 19

Учасник

Зареєстрований: 2019-01-27

Повідомлень: 1

Помогите новому Ардуинщику

После установки вин 10 не все контроллеры могу прошить. 8266 прошивается, нано нет, во что пишет avrdude:
stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xbc
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0xbc
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0xbc
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0xbc
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0xbc
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0xbc
avrdude: stk500_recv(): programmer is not responding
Проблема загрузки в плату. Помощь по загрузке: http://www.arduino.cc/en/Guide/Troubleshooting#upload .
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0xbc
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0xbc
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0xbc
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xbc

renoshnik

Учасник

Зареєстрований: 2017-04-03

Повідомлень: 1,025

Re: Помогите новому Ардуинщику

все полируют ХШ, подождите немного .